HMT Rivet Removal Range
The complete range of HMT rivet removal solutions can be seen below and gives solutions for drilling accessible rivets, distance drilling, drilling rivets with obstructed access, enlarging and cleaning out old rivet holes and tight access drilling.
VersaDrive TurboTip Pilot DrillBit
6.35mm
High speed, impact and rotary rated drill bit that can be used to pilot drill the rivet and avoid removing the pilot pin from the holecutter
VersaDrive TCT Rivet HoleCutter
55mm Depth of Cut
12 - 80mm Cutting Diameters Available
VersaDrive Extra Long TCT Rivet HoleCutter
100mm Depth of Cut
14 - 26mm Cutting Diameters Available
HoleCutter Pilot Drill Bit
Supplied with the TCT Holecutter and can be used to pre-drill the rivet head, allowing the holecutter pilot pin to centre the holecutter during the main cut
HoleCutter Pilot Pin
Used to guide, stablise and centre the HoleCutter during the main cut. Whilst the pilot drill bit can also be used for this, the solid pin is less prone to breakage if the HoleCutter ‘snags’.
CarbideMax TCT Broach Cutter
40mm - 110mm Depth of Cut
12 - 80mm Cutting Diameters Available
CarbideMax Extra Long TCT Broach Cutters
Up to 200mm Depth of Cut
18 - 200mm Cutting Diameters Available
VersaDrive Impact Reamer
11mm VersaDrive Shank
8 - 26mm Cutting Diameters Available
VersaDrive MAX Impact Reamer
20mm VersaDrive MAX Shank
18 - 41mm Cutting Diameters Available
Speedlube Aerosol Lubricant
High performance, aerosol propelled lubricant that foams on contact to ensure maximum tool coverage and heat dissipation
OverReach System
Position Magnetic Drills in otherwise inaccessible locations
V35 Compact Magnet Drill
Lightweight, flexible mag drill with 110mm cutting depth & seamless integration with the VersaDrive® system
RTQ40 Low Profile Magnet Drill
Ideal for tight access applications
Suitable for use with any standard broach cutter up to 40mm cutting depth
VersaDrive Impact Wrench Adapter
Available in 1/2" and 3/4" drive sizes
Converts Impact Wrenches for use with VersaDrive® TurboTips and Impact Reamers
VersaDrive Magnet Drill Adapter
19.05mm (3/4") Weldon Shank (fits all standard mag drills)
Magnet Drill Adapters are available to allow TCT Holecutters to be used as an annular cutter in a Standard Magnetic Drill
VersaDrive 130mm Extension Arbor
VersaDrive extension arbors are available in 130mm & 300mm working length to assist reach in confined or otherwise inaccessible locations such as corners
VersaDrive 300mm Extension Arbor
VersaDrive extension arbors are available in 130mm & 300mm working
length to assist reach in confined or otherwise inaccessible locations such as corners
VersaDrive SDS+ Adapter
SDS Adapters convert VersaDrive HoleCutters for use in SDS+ Drills in Rotary only mode